FULL ECU Tool package

The Full ECU Tool package contains the EP001, EP003 and EP005.

The EP001 ECU Programming Tool is dedicated to full reading/writing/updating and checksum correction of Dflash, Internal/External Pflash and Map Files of Engine Control Units by bench (direct connection), boot mode and diagnostics (OBDII).
The ECU Programming Tool allows also the virtual reading of Flash, Maps and Bootloader.

Supported ECUs:

• Bosch EDC17/MED17
• Delphi
• Continental/Siemens SIMxx
• Kefico

The EP003 license allows the full reading/writing/updating of PFlash, DFlash and Maps, as well as checksum correction of MD/MG Engine Control Units and VGS2-FDCT/ZF 8HP/DQ381Transmission Control Units on bench.
The procedures allow exchanging these modules in a wide selection of vehicles.
 
Supported ECUs:

• MD/MD1 with SPCxxx and TC2xx
• MG/MG1 with SPCxxx and TC2xx

 
Supported TCUs:

• VGSNAG3 9G-tronic
• VGS2-FDCT
• ZF 8HP
• DQ381
• Getrag 7DCT300

Active AMS and Internet connection are required for the procedures. When working with MD/MG ECUs, you will need the CB023 or CB030 connection cable. In case you need to program a ZF 8HP TCU, use the ZN079 connection cable.

• The EP005 license also supports Read/Program Application, Maps and SPI EEPROM of engine control units Continental MCM, MCM02T, MCM2.1 and adblue control modules ACM, ACM2.0, ACM2.1, ACM2.2 by OBDII and direct connection on bench
• Checksum alignment while programming
• Option for full PFLASH/DFLASH/SPIEEPROM backup of the these modules

 
Supported brands:

• Mercedes-Benz Trucks
• Mercedes-Benz Buses
• Akia Busses
• Bell Equipment
• Claas
• Fendt
• JCB
• Krone
• Magni
• Manitou
• Morelo Buses
• Ponsse
• Sterling
• Western Star

Click here for a detailed list of all supported ECUs.

An AVDI interface with an active AMS and Internet connection, as well as the ZN051 Distribution Box are required for the procedures.