The PN0018 is on the front line in the aftermarket solutions for key and remote control programming for the Peugeot/Citroën vehicle range. Abrites diagnostics for Peugeot/Citroën always manages to be one step ahead in terms of PIN code reading and key/remote control programming in these vehicles making the PN018 an absolute leader in this field.
With this special function you can read PIN codes from the BSI module. Supported models are all CAN and UDS protocol models which includes almost all models produced after 2004. Support for Delphi UDS BSI 2016+ is also included.
This function can be used independently.
- Support for Delphi UDS BSI 2016+ (used in various models for example: C3 III, C4 II Picasso 2016+, Peugeot 3008 II, Peugeot 5008 II, DS7 etc.) - read PIN, odometer correction with disabling dashboard synchronization, ID change, skip time wait mode when learning a new key, clear Faults Log
PN017 is a function dedicated to the Instrument cluster and BSI odometer data calibration in Peugeot/ Citroën. With this special function you can read and calibrate the mileage stored in the BSI module and remove the synchronization with the instrument cluster (i.e. The modification is performed in the BSI exclusively and after a complete ignition cycle the mileage is not restored to the original value). In the cases where the sync removal does not apply it can calibrate the mileage in the cluster exclusively. Supported models are all CAN and UDS protocol models which includes almost all models produced after 2004.Support for Delphi UDS BSI 2016+ included.
BSI Exchange - allows you to read the whole content of the one BSI (JCI or Valeo CAN) and transfer it to another one. It is very important to use the same hardware type for the replacement BSI. The Valeo BSIs are two types – the old one is thick, while the new one is thin, so they can’t be mistake...
The PN009 is a special function dedicated to reading and updating the Configuration data, reading and updating the flash, making IMMO OFF, resetting service intervals and changing the PIN codes of Engine Control Units of different ECUs in Peugeot/Citroën vehicles. Users are enabled to:
Read and write the EEPROM of the EDC15, EDC17(BOOT MODE), SID201, SID801, SID801A, SID802, SID803, SID803A, SID804, SID806;
Read and calibrate the mileage in the dashboard of EDC16, EDC17(BOOT MODE), SID201, SID801, SID801A, SID802, SID803, SID803A, SID804, SID806;
Read and change the PIN of EDC15, SID201, SID801, SID801A, SID802, SID803, SID803A, SID804, SID806;
Modify the service intervals of EDC15, SID201, SID801, SID801A, SID802, SID803, SID803A, SID804, SID806;
Read and write the EEPROM of EDC15 Engine ECUs and make Immo OFF,as well as after sales and edit service list.
Supported models are all models using the following electronic...
Special function PN019 allows the user to perform changes to various coding parameters in the modules of PSA vehicles including 2021 models. This allows the user to both to change current configuration parameters but also to perform retrofits in the vehicle and coding them as though they were originally fitted to the car in question.
N.B. Please note that you will require an AVDI interface with an active AMS in order to use this special function. No tokens are required.